Go to your saved Cartridges

Custom Factory Crimp Dies

Please allow 8 weeks for production.

Unable to make the following cartridges:

  • 11mm French (too short)
  • 17 Ackley Bee (too small)
  • 17 Mach IV (too short)
  • 19 Badger (too small)
  • 22 Rim Fire
  • 22 LR (too short)
  • 32 NAA (too short)
  • 22 Rem Jet (too short)
  • 32 S&W Short (too short)
  • 38 S&W
  • 38/45
  • 38 Short Colt
  • 38 Long Colt
  • 41 Long Colt
  • 256 Winchester Magnum
  • 310 Cadet (too short)
  • 460 S&W (you can use the # 90865 Carbide Factory Crimp Die for this cartridge to apply a Factory Crimp and post-size part of the case)
  • 475 Linebaugh
  • 500 Linebaugh (too sort for large series die body and too large for standard series die body)
  • 50 AE (case diameter is too large to fit in the 7/8-14 die and too short for large series as a collet type crimp die. It can not be made as a carbide crimp die because the carbide would end up being too thin to have the necessary strength. If you wish to separate the bullet seating and crimping steps then purchasing a separate seating die body is your best option.)
  • 50 GI (too large)
  • 50/100 Win Express
  • 7.62 Model 1895 Russian Nagant Revolver
  • 7.62 x 12
  • 7.62x25 (too small)
  • 7.63 Mauser
  • 7.65mm
  • 7.92x33 Kurz (too small)
  • 50/70 (too large)
  • 50/95 (too large)
  • 56/60 Spencer (too large)
  • 500 Cor Bon
  • 500 S&W (use the # 90931 Collet Style Factory Crimp Die)
  • 510 GNR (too short)
  • 8mm Kurz (too small)
  • 8mm Nambu (too small)
  • 9.4 Dutch Revolver (too short)

Custom Rifle Factory Crimp Die

The Factory crimp die can be made for a wide variety of cartridges. Most cartridges will fit into the 7/8 x 14 thread die body. If your cartridge falls within the following parameters it will fit the standard 7/8 x 14 die:

  • Bullet diameter .172" - .501" (minimum - maximum)
  • Body diameter .295" - .562" (minimum - maximum)
  • Case length 1.250" - 2.850" (minimum - maximum)

Custom Large Series Factory Crimp Die

Cartridges over the maximum in any of the above three parameters will probably fit into the Large Series Die 1 1/4x12 thread, so your press must be capable of accepting this thread size. The only press we manufacture that can accept the Large Series Dies is our Classic Cast Press.

Note: If you are using a competitor's press with removable bushing, consider our 1 1/2-12 to 1 1/4-12 die adapter bushing. This bushing will allow you to install these dies into your press.

  • Case diameter at base .563" to .640" (minimum - maximum)
  • Case Length over 2.850"
  • Bullet diameter .501" to .600" (minimum - maximum)
Sort by

Custom Rifle Factory Crimp Die

90595
$30.00

Custom Large Series Factory Crimp Die

90597
Custom Large Series Factory Crimp Die 1 1/4 x 12" Thread
$125.00