Hand Gun Dies

Select the Deluxe Pistol 4-die set when using mixed range brass or brass that was fired in others guns. The Deluxe set includes the Carbide Factory crimp die. This die allows you to separate bullet seating from the crimping operation. It makes setup much easier and the die has the added feature of a carbide resizer that does a finishing sizing pass on the completed round. This final sizing guarantees that any case that passes through the die will freely and reliably chamber in any gun.

The carbide & steel three die sets work fine when using a quality controlled source of brass, like cases fired only in your gun. More care is required when adjusting the bullet seat and crimp die, as seating and crimping occur simultaneously. Bullet diameter control is important when not using the factory crimp.

Lee Breech Lock Press Owners, check out the Breech Lock Carbide 4-Die Set or Breech Lock Carbide 3-Die Set. These off ther best value for Lee press owners. Ships with colored, quick change busings already on the die for quick change convenience.

Reloading sequence:

Carbide Sizing Die	Powder Through Expanding Die	Bullet Seat & Feed Die	Carbide Factory Crimp Die

---

Lee offer the most complete reloading die sets, all die sets include:

FREE universal press shell holder, some manufacturers charge $18.00 extra for this necessary part

FREE comprehensive load data when availalbe, priceless on obsolete cartridges

FREE powder measure to dispense the charge

FREE Lee Resizing lubricant on steel full length sets

Exclusive easy to adjust and tighten lock rings with integral o-ring

Exclusive Sizing die is so durable- can be used as a built-in stuck case remover.

---

To quickly find the Lee products available for the cartridge(s) you intend to reload, use the cartridge drop-down at the top of every page.

---