Lee Precision
Custom Large Series Factory Crimp Die
Custom Large Series Full Length Sizing Die
Large Series Full Length Sizing Die Only (1¼ -12 thread)
Custom Large Series Full Length Sizing Die Setup Charge
SETUP CHARGE
Large Series Full Length Sizing Die ( 1¼ -12 thread)
Custom Large Series Neck Sizing Die only
Custom Collet Neck sizing die 1 1/4x12" (large series) thread.
Custom Neck Sizing Die only
Neck sizing die uses a steel collet to squeeze fired case to a precision mandrel, creating a precisely aligned case neck while reducing run out. Results in best accuracy and extended case life. Sizes just the neck and requires no case lubrication. Recommended for cases that have been fired through your firearm only.
Please indicate required fields below. You will need a fired piece of brass to measure. For assistance in determining the dimensions, please view this document. View cartridge listing for shell holder assignment, view list here.
If you need assistance populating dimensions, please mail your two fired cases and sample bullet into the factory to the address below, we can then measure and place the order for you.
Lee Precision, Inc.
4275 County Road U
Hartford, WI 53027
Custom over-run 270-08 Factory Crimp Die
Lee 270-08 Factory Crimp Die crimps the bullet in place more firmly than any other tool. Tests demonstrate that even bullets which have no crimp groove will shoot more accurately. A firm crimp improves accuracy because pressure must build to a higher level before the bullet begins to move. This higher start pressure insures a more uniform pressure curve and less velocity variation.