Lee Precision
40 Smith & Wesson / 10MM Carbide Factory Crimp Die
Click here to view parts
Lee 40 S&W/10mm Auto Carbide Factory Crimp Die sizes the cartridge while being crimped so every round will positively chamber freely with factory like dependability. This die applies a taper crimp. The adjusting screw quickly and easily sets the desired amount of crimp. Trim Length is not critical so this extra operation takes less time than it would if cases were trimmed and chamfered. A firm crimp is essential for dependable and accurate ammunition, as it eliminates the problems of poor ignition of slow burning magnum powders.
40 Smith & Wesson / 10MM Undersized Carbide Sizing Die Only
.003" Undersize Carbide Sizing Die 40 S&W/10mm
40 Smith & Wesson Breech Lock Carbide 3-Die Set
Click here to view parts
Lee 40 S&W Pistol Breech Lock 3-Die Set includes colored Smart Lock bushings for easy die identification, Carbide Full Length Sizing Die, Bullet Seating Die, Powder Thru Expanding Die, Universal Shell Holder, Powder Dipper and Instructions/Load Data. Select this die set if you are reloading mixed range brass and have the Breech Lock Quick Change feature on your reloading press.
Note: can be used to load the 10mm Auto. Back out the bullet seating die and powder through expanding die 1 3/4 turns. 10mm Load Data is found in "Modern Reloading" or available for purchase here. Can also be used to reload the 41 Action Express. The powder through expander and bullet seating die would have to be backed out approximately two turns. The load data included with the dies can not be used with the 41 Action Express, it would have to be obtained through one of your favorite powder manufacturers.
40 Smith & Wesson Carbide 3-Die Set
Click here to view parts
Lee 40 S&W Pistol 3-Die Set includes Carbide Full Length Sizing Die, Bullet Seating Die, Powder Thru Expanding Die, Universal Shell Holder, Powder Dipper and Instructions/Load Data.
Note: can be used to load the 10mm Auto. Back out the bullet seating die and powder through expanding die 1 3/4 turns. 10mm Load Data is found in "Modern Reloading" or available for purchase here. Can also be used to reload the 41 Action Express. The powder through expander and bullet seating die would have to be backed out approximately two turns. The load data included with the dies can not be used with the 41 Action Express, it would have to be obtained through one of your favorite powder manufacturers.
