Go to your saved Cartridges

Bullet Feed Kit

The Bullet Feed Kit is designed to directly fit the Pro 1000. Automatically feeds bullets into the mouth of the bullet seating die. Align bullets more accurately than possible by hand and increases the cyclic rate 50 to 100%. The Bullet Feed Kit is complete for one bullet diameter and range of length. To determine which Bullet Feeder you need, you will need to measure the bullet's diameter and, most importantly, the length of the bullet in inches. To convert to another caliber or bullet length select appropriate Feed Die & Finger and purchase corresponding Lee bullet seat and feed die.

Note for Pro 1000's built prior to 1992:  these presses do not have the attach lug necessary to mount the Bullet Feed Kit to the carrier. If you have an older carrier, please purchase a new one here.

The tube holds 25 bullets. The kit comes with 2 tubes (small and large), when you load small bullets, the small tube fits inside the large tube. When you load large bullets, the small tube is removed.

The Multi-Tube Adapter accessory for the bullet feed kit will allow you to hold approximately 100 bullets.

The Bullet Feed Kit is available in the following bullet diameter's and length's only, click on your size for additional product descriptions. 

Please note, the bullets that work the best in the bullet feeder are jacketed or lead round nose flat base bullets.


30 & 32 cal Bullets up to .60 long
9mm (.355) through .365 diameter up to .46 long
9mm (.355) through .365 diameter .46 to .60 long
9mm (.355) through .365 diameter .60 to .75 long
40 cal through .44 cal up to .65 long
40 cal through .44 cal .65 to .80 long
45 cal bullets up to .67 long



Multi-Tube Adapter for Bullet Feed Kit

Sort by
Display per page

Bullet Feed Kit 45 CAL TO .67LN


Click here to view parts


Multi-Tube Feeder


Click here to view parts