455 Webley Mark II Dies

Click here to view parts

Click here to view parts

45 GAP, 455 WEBLEY MARK II pistol bullet seating die only complete.

There are two crimp shoulders in our pistol Bullet Seating Dies. The first shoulder applies a slight taper crimp and the second shoulder applies a full roll crimp. The closer the die is adjusted to the shell holder the heavier the crimp will be.

Consider completing the bullet seating die with handgun micrometer adjuster. Provides precision bullet seating depth. Easy to read laser engraved divisions represent .001" of an inch. No clicks, just smooth adjustment.

Click here to view parts

Click here to view parts

Lee 45 Colt, 454 Casull, 460 S&W** Carbide Factory Crimp Die sizes the cartridge while being crimped so every round will positively chamber freely with factory like dependability. This die applies a roll crimp. The adjusting screw quickly and easily sets the desired amount of crimp. Trim Length is not critical so this extra operation takes less time than it would if cases were trimmed and chamfered. A firm crimp is essential for dependable and accurate ammunition, as it eliminates the problems of poor ignition of slow burning magnum powders.

**460 S&W (you can use the # 90865 Carbide Factory Crimp Die for this cartridge to apply a Factory Crimp and post-size part of the case)

45 cal. heavy duty guided decapper.

Click here to view parts

Click here to view parts