Go to your saved Cartridges

Your Armory

  • Your Armory is empty.

Can't find what you're looking for? Open a ticket and we will help you find it!

7.5MM Schmidt-Rubin

New drawing Coming

For critical safety information, refer to the article:

https://support.leeprecision.net/en/knowledgebase/article/7-5-x-55-swiss.

Those who find that discussion confusing are welcome to visit the Internet where the discussions are more complete and equally far more confusing. I must admit I remain concerningly confused! The important points are:

Older-model guns have a slightly different chamber

The older guns also work at significantly lower pressure


The modern 7.5×55 Swiss chambering and associated Military loads have a seriously storied history. The standard Swiss WW-II Military load used a bullet that was so efficient the U. S. adopted it for use in its anti-aircraft and armor piercing 30-06 rounds. Then, it had to discontinue that loading after discovering the bullet was so efficient it would shoot off most, if not all, U. S. Military rifle ranges!

This case was the progenitor of the 284 Winchester. Running 284 cases through the 7.5×55 die results in entirely functional 7.5×55 cases, despite the 0.027-inch difference in rim diameter. Ballistically, when loaded to full potential for the more modern rifles, the 7.5×55 comes close to duplicating 30-06 performance, which is no faint praise.


The text associated with the cartridge description reflects opinions and conclusions of the author, M.L. (Mic) McPherson. Lee Precision and its employees do not necessarily either agree or disagree with any of his comments. We present these with due deference to his recognized expertise in the firearms field. His acumen extends to handloading and all aspects of ballistics - internal, external, and terminal.
Die Sets
Lee Collet Necksizing 2-Die Set
Lee RGB Die Set
Lee Full-Length Sizing Die Set
90767 (3-Die set)
Lee Breech Lock Die Set
Lee Ultimate 4-Die Set
Lee Loader
Single Dies
Full-Length Sizing Die
91069
Sizing Die
Neck Sizing Die
91015
Undersize Sizing Die
Charging Die
Seating Die
91431
Factory Crimp Die
90184 (Collet Style)
Taper Crimp Die
Inline Bullet Feed Die
Die Accessories
Guided Decapper
Undersized Flash Hole Decapping Mandrel
Undersized Mandrel
Case Conditioning Tools
Case Length Gauge and Shell Holder
Quick Trim Die
Presses
Reloader Press (50 RPH)
Hand Press (50 RPH)
Challenger Press (50 RPH)
Classic Cast Press (50 RPH)
Value Turret Press (250 RPH)
Classic Turret Press (250 RPH)
Ultimate Turret Press (250 RPH)
Pro 1000 Press (500+ RPH)
Pro 4000 Press (500+ RPH)
Six Pack Pro Press (500+ RPH)
Shell Plates and Holders
Priming Tool Shell Holder
90203 (#3)
Universal Press Shell Holder
90520 (R3)
X-Press Shell Holder (APP)
91536 (#3)
Pro 1000 Shell Plate
Auto Breech | Pro 4000 Shell Plate
90629 (3)
Six Pack Pro Shell Plate
91837 (3L)
Inline Bullet Feed
Inline Bullet Feed Die
Inline Bullet Feed Kit
Inline Bullet Feed Magazine
Bullet Casting
Classic Bullet Sizing Kit
Breech Lock Bullet Sizer and Punch
Bullet Molds

Challenger III

From $117.00

Ultimate Turret Press

From $320.00

Deluxe APP Press Kit

91898

The Lee Deluxe Automatic Processing Press gives you the same priming convenience found only on expensive progressive reloading presses.

$155.00

Six Pack Pro Press

From $400.00